CTCL AUTODESK FORUM

CENTRAL TECHNOLOGY CENTRE LIMITED AUTODESK USERS FORUM

block sizing

Post new topic   Reply to topic

CTCL AUTODESK FORUM :: Autodesk Software :: General Discussions

View previous topic View next topic Go down

block sizing

Post by chrizz on Tue Jul 22, 2008 10:31 am

I have created a block and it is stored in my design centre. But when i try to insert it in a drawing, the block comes out really small.
How can i get it inserted to its original size. Crying or Very sad

chrizz

Gender:Male
Posts : 1
Joined : 25 Mar 2008
Job/hobbies : teacher

Back to top Go down

Re: block sizing

Post by Admin on Tue Jul 22, 2008 11:16 am

Check your block insertion scale in the units dia box make sure it is set to the same units as the block creation settings

Admin
Admin

Gender:Male
Posts : 43
Joined : 18 Mar 2008
Location : Trinidad
Job/hobbies : Senior Lecturer

Back to top Go down

View previous topic View next topic Back to top

Post new topic   Reply to topic

CTCL AUTODESK FORUM :: Autodesk Software :: General Discussions

Permissions of this forum:
You can reply to topics in this forum