Parametrics: Dynamic Blocks for 2011 - Dimensional Constraints

Go down

Parametrics: Dynamic Blocks for 2011 - Dimensional Constraints

Post by Shauna Charles on Wed Nov 09, 2011 8:55 am

Parametrics: Dynamic Blocks for 2011

Dimensional Constraints

Dimensional Constraint parameters can be added to dynamic block geometry. Their name is in turn exposed as a property for the block, much like the standard dynamic block parameters. When attaching Dimensional Constraints to block geometry, you can also control the number of grips available to the user for editing purposes.

NOTE: Be sure your constraints are contained in the block definition, not added after the fact for the best results.

TIP: Be sure to stick to the Block Editor ribbon when attaching dimensional constraints. (Donít grab them from the Parametrics tab!)

Shauna Charles

Female Number of posts : 53
Location : Trinidad
Job/hobbies : AutoCAD Technician / Lecturer
Registration date : 2008-03-19

View user profile

Back to top Go down

Back to top

- Similar topics

 
Permissions in this forum:
You cannot reply to topics in this forum